Forgive me if I am missing the obvious, but with the new interface in 3.9.D12 (cutting operations along the bottom) I cannot find the setting for z step down. Can anyone enlighten me as to where this is hiding?
Thanks!
What I learned today: Contour and Level don’t appear to have a z step down setting, but Rough does. Does anyone else think that a stepdown for operations other than Rough would be helpful for them?
rough, outline, trace, pocket, and drill all have setup down because they clear material in multiple z passes. contour is a finishing pass that follows the surface, so it does not have a step down. level is a single surfacing pass to level stock, so it does not have step down.
1 Like