Direct drive 2 mount

GridBot
1

Currently running bowden on my GridBot but would like to try out direct driven extruder.

In which position is the direct drive 2 mount supposed to be printed? I suppose it need a lot of support?

2

As I recall, I printed it like this. Not too much support.

Screen Shot 2021-03-22 at 6.57.12 PM
Screen Shot 2021-03-22 at 6.57.12 PM1354×1092 155 KB
Screen Shot 2021-03-22 at 6.57.02 PM
Screen Shot 2021-03-22 at 6.57.02 PM1406×804 171 KB
Screen Shot 2021-03-22 at 6.56.51 PM
Screen Shot 2021-03-22 at 6.56.51 PM1486×1466 206 KB

1 Like
3

Thanks, I’ll give it a try the way you did it.