# Ease down not always working

**URL:** <https://forum.grid.space/t/ease-down-not-always-working/1128>\
**Category:** CAM\
**Created:** [January 17, 2024, 5:43pm UTC](https://forum.grid.space/t/ease-down-not-always-working/1128 "2024-01-17T17:43:48Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![acp693](https://forum.grid.space/letter_avatar_proxy/v4/letter/a/c57346/32.png) [@acp693](https://forum.grid.space/u/acp693)\
**Post date:** [January 17, 2024, 5:43pm UTC](https://forum.grid.space/t/ease-down-not-always-working/1128/1 "2024-01-17T17:43:48Z")

</div>

Hi, I’ve used Kiri-Moto a lot over the last year or so, it’s getting better and better! I’ve noticed on quite a few generated g-code files though that although ‘Ease Down’ occurs reliably at the beginning of an operation, often in the middle of an operation, the endmill just plunges straight down.

Recently I’ve started using bigger diameter cutters and when they plunge straight down it puts a tremendous stress on the machine. How hard/complicated would it be to have the cutter spiral or ramp down every time it cuts newly into the surface?

Thank you again for all your very hard work!

---

<div class="post-metadata">

**Author:** ![stewart](https://forum.grid.space/user_avatar/forum.grid.space/stewart/32/21_2.png) [@stewart](https://forum.grid.space/u/stewart)\
**Post date:** [January 17, 2024, 6:42pm UTC](https://forum.grid.space/t/ease-down-not-always-working/1128/2 "2024-01-17T18:42:00Z")

</div>

ease-down is a work in progress. there are areas of the code where it’s not implemented. I have this slated for a refactor because the current code isn’t structured properly to make this easy.

---

<div class="post-metadata">

**Author:** ![acp693](https://forum.grid.space/letter_avatar_proxy/v4/letter/a/c57346/32.png) [@acp693](https://forum.grid.space/u/acp693)\
**Post date:** [January 17, 2024, 7:28pm UTC](https://forum.grid.space/t/ease-down-not-always-working/1128/3 "2024-01-17T19:28:11Z")

</div>

Thanks Stewart, any idea about a timeline for the refactor? Looking forward to it!

---

<div class="post-metadata">

**Author:** ![stewart](https://forum.grid.space/user_avatar/forum.grid.space/stewart/32/21_2.png) [@stewart](https://forum.grid.space/u/stewart)\
**Post date:** [January 17, 2024, 8:06pm UTC](https://forum.grid.space/t/ease-down-not-always-working/1128/4 "2024-01-17T20:06:41Z")

</div>

I had expected to start it early this year, but the new job has me tied up. Might be a few months.
